GFI MailSecurity, 25-49, 2 Year SMA Installation Manual download pdf (Page 77)

GFI MailSecurity for Exchange/SMTP Configuring Attachment Checking  69

Make changes to an existing rule

To modify an existing rule:

1. Click the GFI MailSecurity  Attachment Checking node.

2. From the Attachment Checking page (in the right window), click the

name of the rule that you want to modify.

3. Make the required changes (for example, Rename the rule, etc.) in

the rule properties and click Apply to accept the changes you made.

Changes will take effect immediately.

Enabling/disabling rules

You can check and change the status of a rule (i.e. enabled/disabled)

from the Attachment Checking page. To enable or disable an existing

rule:

1. Click the GFI MailSecurity  Attachment Checking node.

2. From the Attachment Checking page (in the right window), select

the check box of the rule(s) that you want to enable or disable.

3. Click Enable Selected or Disable Selected accordingly. The status

change is displayed immediately under the Status column.

Changing the rule priority

Attachment Checking rules are applied in the same order, from top to

bottom, as they are listed in the Attachment Checking page. However,

you can change the sequence/priority of a rule as follows:

1. Click the GFI MailSecurity  Attachment Checking node.

2. From the Attachment Checking page (in the right window), click the

(up) or (down) arrows to respectively increase or decrease the

priority of the required rule(s). Repeat until the rule reaches the

desired position in the list (i.e. until the rule is assigned the desired

priority).

NOTE: You can check the priority of rules from the Attachment

Checking page. The priority value of each rule is displayed in the

Priority column.

1 2 ... 72 73 74 75 76 77 78 79 80 81 82 ... 199 200

No comments

GFI MailSecurity, 25-49, 2 Year SMA Installation Manual Page 77